![]() ![]() A precision ground gate, 38mm wide, is centered on each of the four edges. The “DyneX” applicator measures only 13 x 13 x 64mm. Remarkably fast and easy clean-up saves time and cleaning supplies. With a Teflon® coated surface it is ideal for Dyne testing – no attraction to, or contamination from the applicator affects test results. See the Metering Rod Selection Chart PDF below for further information. With the use of such non-abrasive cleaners, metering rods can be reused repeatedly. Economical and easy to use simple clean-up with water, alcohol, appropriate solvent and low lint cloths. These lab rods or drawdown bars can be used either to test two coatings simultaneously, or for full width substrate evaluations using one test liquid. ![]() Rods are available in 6.3mm and 12.7mm diameters. The 400mm long “Mayer” rod has 305mm of wire wound on centre. The rods, widely known as Metering Rods, Mayer Rods or drawdown bars are fabricated from 303 stainless steel the wire winding is 304 stainless steel. Liquid crystal thermometer is accurate to better than 1☌.Īpplies a highly uniform wet film coating.These wire-wound metering rods, when used on a precision surface such as the “DyneX” Drawdown Platform, will apply a highly uniform wet film thickness, which is ideal for Dyne testing. Five pre-adjusted shock absorbing levelling feet and surface mounted spirit level ensure precise levelling and firm footing. Each unit is meticulously inspected to assure flatness. The 305mm x 305mm smoothing pad with closely controlled compressibility is engineered to promote uniform fluid distribution with minimal squirm. 12.7mm thick float glass platform large enough for direct A to B comparisons or evaluation of machine caused treatment variations. ![]() Full width magnetic clamp allows precise sample positioning with secure grip. ![]()
0 Comments
Leave a Reply. |